- ROUTER ON A STICK IP ROUTING OPERATIONAL 9TUT NO FURTHER UPDATE
- ROUTER ON A STICK IP ROUTING OPERATIONAL 9TUT NO FURTHER SOFTWARE
- ROUTER ON A STICK IP ROUTING OPERATIONAL 9TUT NO FURTHER MAC
In this case, the modem has missed the MDD message and flags the occurrence. As in, for the modem to operate correctly, go to this channel to receive the data required to operate a network between the CMTS and modem, in a nutshell. For the MDD, the CMTS broadcasts channel data to the modem so that the modem knows exactly what channels are used to carry network operational data.
ROUTER ON A STICK IP ROUTING OPERATIONAL 9TUT NO FURTHER MAC
The other events are the MDD IP Mode Overide (MIMO) and Lost MAC Domain Descriptor (MDD) event, which can be more problematic although their only marked as warnings. Its unfortunate that this is logged as a critical event, when in fact the modem simply carries on, requesting another maintenance period very shortly thereafter. So the fact that there are a number of these could either indicate that the CMTS is busy or that there is an issue with packet loss. If the modem doesn’t see a response to the maintenance period request, it logs that receive failure and carries on, only to request the maintenance period once again, very shortly down the road, so to speak. This ensures that the modem time sync with the CMTS is correct and that the CMTS data that is required by the modem to operate correctly is in fact received by the modem. The modem requests maintenance periods from the Cable Modem Termination System (CMTS) on an ongoing basis. Have you had any field techs visit to check your external cabling and have a number of no responses to Unicast Maintenance Ranging and No Ranging Response. The pasted table should look like the table in the modem.ĭid tech support ever run a signal check on your modem? Select or highlight, from the start of the Downstream Overview line, all the way to the bottom right hand corner of the bottom OFDMA/OFDM section, right click.
ROUTER ON A STICK IP ROUTING OPERATIONAL 9TUT NO FURTHER SOFTWARE
If you're having that much luck in finding unserviceable modems, you should be buying lottery tickets.Īt best, I think you should see two or three events logged per day in the event log, and they should only be minor entries.Ĭan you log into the modem and confirm what Software (firmware) version is currently loaded as shown on the STATUS page. One unserviceable modem, I'd believe, three unserviceable modems, no way. The modems are pretty reliable, despite the impression that Tech Support might have given you. Assuming that works, it implies that there's an issue with the PfSense configuration that is stopping any traffic to or from I'd bet that you have some problems that go beyond the modem. Try accessing the modem thru the other router. After the modem reboot both routers should have their own separate IP address. Would you happen to have an old router on hand that you're not using anymore? If so, connect that router to another port on the modem and reboot the modem with both routers already running. Is there any chance that PfSense has data cached from previous modems that might cause this, even if its the same modem model? That doesn't necessarily apply to something like PfSense, but, who knows. My usual advice to anyone switching modems, is to run a factory reset on the router to clean out any data that was specific to the previous modem.
ROUTER ON A STICK IP ROUTING OPERATIONAL 9TUT NO FURTHER UPDATE
Any chance that 192.168.100.1 stopped working after a PfSense update or after a rule creation to block a range of IP addresses?Īs a test case, have you tried creating a rule to allow access to 192.168.100.1, thru the router, just to see if that made a difference? That has come up before, not necessarily with PfSense, but with other routers, to allow access to 192.168.100.1 thru the router.